Rovenlissa Premium Garage Floor System

Our flagship: a premium garage floor system — a polyaspartic resin floor with a full decorative flake broadcast and a high-build clear top coat for a showroom finish, enough for a large or double garage, with the full prep, applicator and anti-slip kit and the edge detailing. A tough, UV-stable, hot-tyre-resistant floor that stays clear and clean; the slab must be degreased, repaired, moisture-tested and ground, then the system applied within its pot life and cured per the data sheet in good ventilation, ideally by a competent installer. The best-looking, longest-lasting garage floor we do.

• Includes: polyaspartic resin, full flake broadcast, high-build top coat, prep + applicator + anti-slip, edge detail
• Benefit: a showroom-finish floor for a large or double garage
• Install: prep, grind and moisture-test; apply within pot life; cure and ventilate per data sheet, ideally by an installer

For a garage or workshop floor. A garage floor must be sound, clean, dry and free of oil and loose material before a covering goes down; interlocking tiles and roll-out mats need a reasonably flat, dry slab, and a coating needs the right preparation — degrease, repair and, for most resin coatings, grind or etch the concrete, with the slab tested for moisture — or the finish will not bond and can peel. Resin and epoxy products are chemicals: follow the mixing ratios, pot life, ventilation and curing times on the data sheet, and wear the stated protection. A fresh coating is slippery when wet until fully cured. Tiles and mats resist most workshop fluids but check the chemical and hot-tyre notes. CE marked where applicable. The statutory 14-day right of withdrawal applies to consumers.