Rovenlissa Epoxy Floor Coating Kit

A two-part epoxy floor coating kit that seals a garage slab into a hard, glossy, wipe-clean floor that shrugs off oil, salt and chemicals, for a single garage. Resin and hardener with optional colour flakes; the slab must be degreased, repaired and ground or etched first, then the mixed coating rolled on within its pot life and left to cure per the data sheet. The classic durable garage floor finish.

• Type: two-part epoxy floor coating kit (single garage)
• Build: resin + hardener, hard glossy chemical-resistant finish, optional flakes
• Install: prep and grind/etch the slab; mix and apply within pot life; cure per data sheet

For a garage or workshop floor. A garage floor must be sound, clean, dry and free of oil and loose material before a covering goes down; interlocking tiles and roll-out mats need a reasonably flat, dry slab, and a coating needs the right preparation — degrease, repair and, for most resin coatings, grind or etch the concrete, with the slab tested for moisture — or the finish will not bond and can peel. Resin and epoxy products are chemicals: follow the mixing ratios, pot life, ventilation and curing times on the data sheet, and wear the stated protection. A fresh coating is slippery when wet until fully cured. Tiles and mats resist most workshop fluids but check the chemical and hot-tyre notes. CE marked where applicable. The statutory 14-day right of withdrawal applies to consumers.