Rovenlissa Full Tiled Floor System

A full interlocking tiled floor system for a single garage — enough impact- and oil-resistant tiles to cover the whole bay, with the edge ramps and corner pieces to finish it, laid loose with no glue in an afternoon. A drainable, hard-wearing floor that takes a car, a jack and a workshop; laid over a flat, dry, swept slab. Everything for one garage floor, matched. Add a system for a second bay.

• Includes: interlocking tiles for a single garage, edge ramps, corners
• Benefit: a whole garage floor laid loose in an afternoon, no glue
• Install: over a flat dry swept slab; add a system per extra bay

For a garage or workshop floor. A garage floor must be sound, clean, dry and free of oil and loose material before a covering goes down; interlocking tiles and roll-out mats need a reasonably flat, dry slab, and a coating needs the right preparation — degrease, repair and, for most resin coatings, grind or etch the concrete, with the slab tested for moisture — or the finish will not bond and can peel. Resin and epoxy products are chemicals: follow the mixing ratios, pot life, ventilation and curing times on the data sheet, and wear the stated protection. A fresh coating is slippery when wet until fully cured. Tiles and mats resist most workshop fluids but check the chemical and hot-tyre notes. CE marked where applicable. The statutory 14-day right of withdrawal applies to consumers.