Rovenlissa Double-Garage Coating System

A complete resin coating system for a double garage — enough primer, body coat, colour flakes and top coat to cover two bays, with the applicator kit and anti-slip additive to lay it, for a seamless, hard, chemical-resistant floor across the whole space. The slab must be degreased, repaired, moisture-tested and ground first, then the system applied coat by coat within each pot life and cured per the data sheet, in good ventilation. A whole double garage, sealed as one floor.

• Includes: primer, body coat, flakes, top coat for two bays, applicator kit, anti-slip
• Benefit: a seamless resin floor across a whole double garage
• Install: prep, grind and moisture-test; apply coat by coat; cure and ventilate per data sheet

For a garage or workshop floor. A garage floor must be sound, clean, dry and free of oil and loose material before a covering goes down; interlocking tiles and roll-out mats need a reasonably flat, dry slab, and a coating needs the right preparation — degrease, repair and, for most resin coatings, grind or etch the concrete, with the slab tested for moisture — or the finish will not bond and can peel. Resin and epoxy products are chemicals: follow the mixing ratios, pot life, ventilation and curing times on the data sheet, and wear the stated protection. A fresh coating is slippery when wet until fully cured. Tiles and mats resist most workshop fluids but check the chemical and hot-tyre notes. CE marked where applicable. The statutory 14-day right of withdrawal applies to consumers.